cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1575
Views
0
Helpful
1
Replies

CISCO IPS Inline mode configuration

sidcracker
Level 1
Level 1

Hello Everyone,

I am going to be implementing an HA Cisco IPS appiiance using inline mode.

This is my diagram..

                         SWITCH 1   -----------------  SWITCH 2

                               |                                    |

                               |                                    |

                               |                                    |

                               |                                    |

                          Cisco IPS                    Cisco IPS

                                |                                   |

                                |                                   |

                                |                                   |

                                |                                   |

---------------------------------------------------------------------------------------

|                                                                                      |

|                         CISCO SWITCH                                     |---------------------Another CISCO SWITCH

|                                                                                      |                                        |

---------------------------------------------------------------------------------------                                 SERVER FARMS

                                          |

                              SERVER FARMS

If there are multiple vlans on the switch connecting to the server farms, then the interface connecting the IPS to the CISCO SWITCH, will be like a mirrored port getting packets from all vlans in all interfaces. Otherwise how else will the IPS get packets from all the servers?

Thanks

Sid

1 Reply 1

rhermes
Level 7
Level 7

The title of your post indicates that you want to place your IPS Sensors in-line.

Mirroring traffic is used with promiscious mode (also called passive or IDS mode).

If your server switch has multiple VLANS that you want to inspect inline, you will need to create VLAN Pairs in the IPS Sensor (one pair for each VLAN you want to inspect). The sensor will translate a VLAN on the server side to a different VLAN on the network side (or whereever Switch 1 and 2 take your traffic). These two VLANS will have different VLAN numbers.

- Bob

Review Cisco Networking for a $25 gift card