Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have an SA-540 that has multiple IPs coming inbound to it.  The WAN port has one IP then there is an additional block of public IPs for my servers.  I have one public IP routing ports 25 and so on into my Mail server's private IP and all mail deliv...

jnrnetworks by Community Member
  • 1099 Views
  • 2 replies
  • 0 Helpful votes

Hi FolksKindly Have a look to the Attached Diagram The Matter is our 3 sites are connected through MPLS Cloud so that in Site 3 I Dont prefere  to go translation to reach the other 2 sites ,and way back...so am thinking to go with NAT Exemption tied ...

I have a CISCO ASA 5520 with ASA version 7.0(8) and ASDM version 5.0(8) I need to upgrade this to ASA Version 8 and ASDM Version 6.I know I am not supposed to upgrade directly to those versions. But do I have to upgrade to each available upgrade firs...

rabih_saleh by Community Member
  • 3375 Views
  • 1 replies
  • 0 Helpful votes

I want to limit the Outbound FTP access from my internet LAN. Is there any way to limit the outbound FTP traffic, also i already have an extended ACL applied on my WAN interface. Please let me know how to limit the traffic .Thanks

hiif asa is not acting as dhcp server and clients behind the inside interface of firewall are having static ip add   is it possible for the firewall to still assign the dns address considering that those dns servers are external to asa firewall . if ...

Resolved! ASA Upgrade

Hello Dears,Below is the Type of Upgrade Support what i have read.I want to upgrade from 8.0.(4) to 8.2.(4) Can i upgrade directly to  8.2.(4) or i have to upgrade first to 8.2.(1). As per the STEP 3 in (Active/Standby Failover Configuration) below w...

I have configured!interface Ethernet0/0nameif outsidesecurity-level 0ip address 2xx.2xx.1xx.x 255.255.255.xxx standby 2xx.2xx.1xx.x!interface Ethernet0/1no nameifno security-levelno ip address!interface Ethernet0/1.11vlan 11nameif insidesecurity-leve...

gnaveen by Level 3
  • 1049 Views
  • 3 replies
  • 0 Helpful votes

hii have 2 ques for qos featue in firewall. i have gone thru qos guide but was not able to figure out1) how can we control or limit the amount of bandwidth for a single host in both inbound and outbound direction . also if the same IP Address is gett...

jvardhan29 by Level 3
  • 5254 Views
  • 10 replies
  • 0 Helpful votes

Hello,The last week i have had a lot of UDP Flood attacks. I can't seem to figure out how i can stop them with my cisco asa 5505.The ports are all closed to the internal IP address (firewall is in transparent mode) accept for a view desired ports, bu...

Review Cisco Networking for a $25 gift card