08-01-2008 02:44 AM - edited 03-11-2019 06:24 AM
Good day all,
I installed a pix 525 between my lan and the service provider. I have done the basic configurations but i can get to my inside port from the lan. please find attached the running configs. Please i need help.
Regards,
Obinna
08-01-2008 03:00 AM
The config you have attached is not OK.
Public IP is assigned to the inside interface and also other things like NATting, routing are missing.
Please check this example to configure your device...
Hope this helps.
08-01-2008 03:07 AM
hi,
Thanks for the reply. Yeah i used public IPs for the inside port because there is a server in the LAN that is doing nating. So, does that mean that this will only work with private IP addresses? Also i'll prefer to configure PAT instead of NAT on the PIX if need be. I have only one IP address on the WAN network.
Regards,
Obinna
08-01-2008 03:56 AM
Suppose this is the scenario,
Outside - 217.117.6.177 - interface e0
inside LAN - 10.0.0.0/24 - interface e1
Default gateway IP - 217.117.6.178
then configuration steps would be something like this...
for Outside interface :
interface e0
nameif Outside
security-level 0
ip address 217.117.6.177 255.255.255.248
for inside interface :
interface e1
nameif inside
security-level 100
ip address 10.0.0.1 255.255.255.0
for doing the PAT (with the outside interface IP :
nat (inside) 5 0 0
global (outside) 5 interface
for the default route:
route outside 0 0 217.117.6.178
08-01-2008 12:05 PM
Thanks alot.
I'm gonna give it a try and get back to you on the result
Thanks one more time
Regards,
Obinna
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide