Cisco sfr Resource is high and unable to deploy policy after upgrade

[schnap]

I upgrade my 2 cisco sfr  to 6.6.5 and then I have an error message configuraton memory allocation (Resource utilization is high) . 

I did the same on 2 other sfr with same asa modele/version and everything went well. 

Any idea ? 

[Sheraz.Salim]

This is a cosmetic bug CSCvx52942 

already this is discussed in thread here at cisco community.

[schnap]

Thanks Sheraz, I already saw the thread and I don't think it's the same problem ....

I opened a ticket with Cisco I'll see. 

I don't have access to the bug idea that you put on the chat . 

Thanks, 

[Sheraz.Salim]

[schnap]

Thanks Sheraz, 

But I don't think it's the same bug. 

My FMC is 7.0.1, and I don't have the exact same  problem that related in the bug . 

The bug describe that we don't have the description on the module but I have the description   but really seems to have a problem with memory . Not cpu but really memory if you check my screenshot. 

[Aref Alsouqi]

Maybe there are some conditions on these two firewalls different than the other ones that went through successfully hence impacting them by doing this upgrade. If this reported issue is preventing you from deploying the changes then I would highly recommend rolling back and raising this with TAC. Alternatively I would try to apply the 6.6.5 patch 1, and then install the latest hotfix.

[schnap]

Aref, 

I finally deployed the policy successufully but still have the error, I open a tac case, we'll see. Thanks,