Network Security

is there a way by which https  can be disabled 

Hi all!Please tell,if there is a strict requirement to work without Smart Account (and SA does not exist for this reason),1) Will new Firepower 1010 out of the box, with FTD image and factory settings, function correctly as a basic firewall? (Without...

Hello friends,I am wondering why there is no deployment with incremental changes.problem :when I changed a line of policy, and then after deployment, all IKEv2 VPN tunnels going to reset!!!!!!I have about 150 tunnels ( S2S with IKEv1 and IKEv2) and a...

I'm trying to find how to mitigate IP TTL Expiry Attack on Cisco ASA 9.1 any idea? 

I have an ASA 5516-X and when I try to activate the 3DES key (that I just recently generated from the licensing portal), it instantly fails with the following error: ASA-MAIN-01(config)# activation-key xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx (i redacted ...

hi,i'm doing a clean up on ASA NAT rules.was planning to disable it first so it's easy to enable it back if there's a user complaint.tried using CLI and ASDM but i don't see a "disable" function for NAT similar to ACL rules.can someone advise if this...

How can i block access to https sites ( youtube & facebook) 

I have one requirement, to create a network group object. The user will provide a set of objects (no object ID, object name, value, type) in the CSV file, I would like to get those object IDs from FMC by using REST API then will create the network gr...

hi actually im trying to add FTD To FMC but im got this error !!Verify the following and retry:- Device is configured to be managed by this Firepower Management Center- Device hostname/IP is accurate; Firepower Management Center and device have conne...

Dear Memvbers, I have Blocked Remote session tools like Teamviewer, Anydesk .etc on ASA 5525. Is it possible if i could allow certain users based on the Remote connection ID or geographical location.

When a use connected to AnyConnect we get the following for a few seconds and then the user is disconnected, Below is the log on ASA .   

All,I'm trying to find out how to accurately find what command will give you the chassis serial number of a PIX. I've seen conflicting info on the web and not which is correct. I've seen that you can execute the "show version" command but I've read...