02-09-2018 11:40 AM - edited 02-21-2020 07:19 AM
Hello,
Well I have this firewall Cisco ASA5516-X firepower with this default configuration:
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 sctp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
I want to edit this configuration on CLI.
please.
regards
02-10-2018 12:19 AM
what and why do you change this configuration? Very often the defaults are absolutely ok. If you change them you exactly should know what you want to achieve.
You can change them with the "timeout ..." command.
02-20-2018 08:18 PM
I need to edit that configuration because the server keep session for more than 1 hour.
I think I need to configurate by expert mode.
02-20-2018 08:29 PM
02-20-2018 08:31 PM
02-20-2018 09:04 PM
02-21-2018 10:21 AM
In GUI that kind of configuration it doesn't exist. I find another mode with "system support diagnostic-cli ".
after that I put "enable" but I don't really sure if I can use "configure terminal" that command doesn't appear.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide