cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

654
Views
5
Helpful
3
Replies
evucinovich
Beginner

Command for version over ASA

Hi there, please i have to look the software version of my asa and when i use show version and then i look the software version it is for example

7.2(4). Ok. Now, it seems the we have same vulneravility over same asa software version. The vulnerability note is Document ID: 107475. It seems that the afected release for example is 7.2 and the first fixed release is 7.2(4)2. What command i have to apply to see my real software version. Thanks.

King Regards.

Elias Vucinovich.

3 REPLIES 3
srue
Rising star

if the output of show version is 7.2(4), then the real version is 7.2(4). 7.2(4)2 is an interim release that you can download. usually its recommended that you only download them if you are affected by a particular bug that a given interim release fixes. they are fully supported by TAC.

at the top of the asa software download page, click "ASA Interim Releases" to find these versions.

Does the interim release shows in the (show version) command? I think it doesn't.

Marvin Rhoads
VIP Community Legend

Yes the interim release does show up in the command output. Here's an example:

ccielab-asa# show ver

Cisco Adaptive Security Appliance Software Version 9.16(1)28 
SSP Operating System Version 2.10(1.159)
Device Manager Version 7.14(1)

Compiled on Fri 09-Jul-21 16:42 GMT by builders
System image file is "disk0:/asa9-16-1-28-smp-k8.bin"
<snip>
Create
Recognize Your Peers
Content for Community-Ad