- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2008 04:34 AM - edited 03-11-2019 05:44 AM
I've noticed a large amt of CRC errors on the outside int of a Pix 515e. We have replaced the cable but the errors are still accumulating; about 48k in the last 24 hours. Bad interface card, do you think?
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2008 07:47 AM
Check the duplex/speed settings on both side of the connections.
This link might help, could rule out config issues if nothing else...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2008 07:47 AM
Check the duplex/speed settings on both side of the connections.
This link might help, could rule out config issues if nothing else...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2008 08:24 AM
Thanks, that was it. I reset the int to auto. Funny thing is that it can't be done thru PDM if failover is enabled. I had to do it thru cli.
