Cs 2611vpn router connected to 2 different Isp

[9e.socco]

I want to have 2 wan links connected to a Cs 2611 (wic-2t) and run gre+ipsec tunnels (half remote tunnels to Isp1, the other half to isp2).

I also want Eigrp for automatic convergence (eg primary tunnel to isp A, secondary to ispB).

Any similar working experiences?

enrico

[wong34539]

You could use two different crypto map on the two serial links, and use the same acl. The tunnel comes up, and normally the traffic goes the way of the first tunnel to come up. Only when the other link goes down then you could use the other link, so in effect you really are not load balancing.

[9e.socco]

I don't want load balancing but a backup tunnel that comes up when the primary tunnel fails;