CSM Deployment Question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2008 10:35 AM - edited 03-11-2019 04:46 AM
Hello,
I have just recently installed Cisco Security Manager 3.1. I have discovered my firewalls. However, in the map view, the CSM does not detect the VPN (site to site) already setup in the firewall config. Also, when deploying a simple access rule, for example, denying a host access to a website, the CSM inserts extra commands(I preview the command and compare to the running-config) then what is required, so I'm hesitant to push out.Is this normal?
-K
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2008 02:30 PM
I found my answer to my question. For those, who has a similar question, please click on the following link:
