Network Security

I have an DSL router connected to a central site via a GRE tunnel. The tunnel is encrypted by IPSEC and works fine.- cisco 836 IOS version c836-k9o3s8y6-mz.123-2.XA6.bin- DSL 7550kbps/864kbps- ipsec encrypted gre tunnel- ipsec tunnel modeI'm trying t...

Hi people,in a 5510 ASA I need to install some public servers in DMZ interface, some of them need to get access to internal network, however, I put a static and the access-list to do that, but logging says theres not translation between them (DMZ and...

Is there a way in vrf to point a radius call to a different server then the one in global routing table.

I have an issue that I am trying to figure out how to fix it. What I am trying to do is this, I need to be able to have a machine on the inside network make a call to a machine in the DMZ using its outside number. I have a 1 to 1 NAT setup for my DMZ...

Hi how are you all doing? I have a quick question here. I've added another inside interface to my Pix eth2 with an ip address of 192.168.50.49 and the distant end is a 2821 g0/0 with ip 192.168.50.50. now from the pix I can ping eth2 but when I try...

Hi,Has anyone any experience converting from their checkpoint firewall to a brand new FWSM blade.Any advice or tips would be much appreciated.

Can the ASA use certificates to perform the authentication of cut-through Proxy?

I setup VPN on our PIX 515E.I have three different VPN Groups setup and lots of Users.My question is how i can assign a number of Users to a Specific Group??Thank you,Zeek

I'm unable to pass traffic from inside my to the internet. From within the FIrewall I can ping the outside interface on the Firewall as well as the internet. Is there something that I need to do on the Firewall to pass traffic past inside interface t...

i have 2 questions1. how can i prevent chatting on PIX 525.2. who can i rest the enabled password of PIX without changing the entire configuration.best regardsthaar