cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4572
Views
5
Helpful
4
Replies

Deployment failed due to failure collecting policies and objects. If problem persists after retrying, contact cisco TAC

jack lee
Level 1
Level 1

Dear all. Our FMC display this failure:"Deployment failed due to failure collecting policies and objects. If problem persists after retrying, contact cisco TAC.", when we deployment ths device. The FMC version is 6.2.2,Firepower version: 6.2.2-81. When we collect the log in the CLI, please help me. the attachment is the CLI logging. than you!

4 Replies 4

Marvin Rhoads
Hall of Fame
Hall of Fame

Like the error says, "contact cisco TAC" would be your recommended course of action.

 

This is community.cisco.com, a free forum, not the TAC paid support venue.

Alan Ng'ethe
Level 3
Level 3

@jack lee 

How did you get past this?

Remember to rate helpful posts and/or mark as a solution if your issue is resolved.

I ended up importing a new instance of FTD into the topology.

Remember to rate helpful posts and/or mark as a solution if your issue is resolved.

Thanks good tip.  Remove HA / remove FTDs.  Log into FTDs cli  - commands: configure high-availability disable (both FTDs) , (both FTDs:) show manager ... if manager is set:  config manager delete followed by config manager add (FMC IP) x.x.x.x KEY (key used by FMC). Add ftds to fmc / add to group / add HA back.  Now working. 

Review Cisco Networking for a $25 gift card