
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2017 07:36 AM - edited 02-21-2020 06:04 AM
Hi Community,
I would like to know the different betwwen SMA M390 and M390X.
Is there any capability on push the configuration to ESA or WSA?
Looking some advice for you guys.
Thanks.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-08-2017 08:26 PM
They are functionally equivalent. The X version has a couple more hard disk drives (8 x 600 GB vs. 6 x 600 GB), allowing it to store more historical events.
http://www.cisco.com/c/en/us/products/security/content-security-management-appliance/models-comparison.html
I'm not sure what you are asking about pushing configuration.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-08-2017 08:26 PM
They are functionally equivalent. The X version has a couple more hard disk drives (8 x 600 GB vs. 6 x 600 GB), allowing it to store more historical events.
http://www.cisco.com/c/en/us/products/security/content-security-management-appliance/models-comparison.html
I'm not sure what you are asking about pushing configuration.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2017 05:30 AM
Thanks Marvin.
Just to ensure that no features for Configuration Master for ESA.
:D
