12-03-2009 09:28 AM - edited 03-11-2019 09:45 AM
using dual core 6509s, can failover be configured on both asa's when using routed interfaces on the core switches instead of using HSRP and L3 vlan?
is there a config / white paper on how to configure this?
12-03-2009 10:40 AM
tsrader wrote:
using dual core 6509s, can failover be configured on both asa's when using routed interfaces on the core switches instead of using HSRP and L3 vlan?
is there a config / white paper on how to configure this?
Probably need a bit more info to understand exactly how you want to set it up but the key point to rememeber is that failover requires L2 adjacency between the 2 ASAs because each corresponding interface on both the active/standby firewalls are in the same subnet.
By the sounds of it you are not proposing to have L2 adjacency beween the ASA devices ?
Jon
12-03-2009 10:45 AM
Hi,
Take a look at the following link:
It is possible to configure ip sla on ASA or if you prefer a routing protocol like OSPF between ASA and 6500.
The link below explains how to configure IGPs on ASA:
http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/ip.html
Br,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide