How is router redundancy completed between 2 different subnets? Or can it? Requirements:Ext-PC1 and Ext-PC2 need to be able to access Int-Server1 and Int-Server2 regardless of router outages. My thinking is to put Ext-RTRs and Int-RTRs on the same ...
Inside to Outside can ping no problemOutside to Inside CANNOT ping host.Requirement is for outside host to be able to access inisde host. (tcp / icmp, etc)I am missing something on the firewall.Relevant configs attached.Thanks for any assistance.
RTR_BUS: Cisco 2901RTR_CUST: Cisco 2901FW: ASA5505Working to connect hosts between differnet subnets with an ASA5505 in between. Relative configs / design is attached.The only requirement is to permit host at 10.10.100.110 to be able to access ho...
Problems trying to connect two Cisco 2901 routers together for LAN-to-LAN application.Just trying to establish connection between PCs on both ends:PC1: 172.16.201.110PC2: 10.10.100.110**************RTR_1 ***************interface GigabitEthernet0/0d...
Thanks again Anil.In our network configuration - the outside network is 10.25.41.x. The inside network does NOT route ANY 10.x.x.x address whatsoever that is why I have the ip route statement on the L3 switch as it is:In order for the inside networ...
Thanks Anil but unfortunately it didnt work. I've provide clarification and partial config.Can anyone tell me what I'm doing wrong and provide configuration guidance???---------------------------------------------------------------Inside network con...
Is this a correct config? Thanks for your reply.outside host (10.25.41.4) needs to access inside host (192.168.195.204)inside: 192.168.195.201 255.255.255.248outside: 10.25.41.1 255.255.255.224virtual ip range: 192.168.191.160 255.255.255.224stat...
The DMZ server ip address (10.x.x.x) is non-routable on the inside network hence the reason for static to inside ip address.Packet tracer results show the following:Phases 1-8 show ALLOWPhase: 9Type: NATSubtype: rpf-checkResult: DROPConfig:static (DM...
