easy question regarding copy and pasting ASA config

[accesshollywood2]

Hey there!

If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...

i dont want anything to error on the pasting of this config.... Help?

[Jon Marshall]

accesshollywood2 wrote:
Hey there!
If i was to give someone a config to paste into an ASA, i need to know where its going to error out. For instance, where do i put my end statements and config t statements...
i dont want anything to error on the pasting of this config.... Help? 

Copy and paste about 20 lines at a time otherwise it can miss some of the input. Start in config mode and it should be fine.

Jon

[John Blakley]

Just to add what Jon said, make sure that the ASAs are identical because of interface differences. You wouldn't be able to paste a config for a 5550 to a 5505 without it erroring out because of the amount and types of interfaces.

HTH,

John