I have been able to get EIGRP working successfully in the lab like I want.
Attached is the network overview:
- We have a Data Center and Corporate office connected via Point to Point Fiber link, eventually we will have two of these
- Two 4948E switches in the Data center acting as cores setup with GLBP
- Corporate Office has a 3750X acting as a core
- Currently two 4948E's are connected to each other via Port Channel and a L2 trunk
- Two set of ASA 5520's one acting as a firewall and for Cisco Any Connect and second for site to site VPN
What is the best way/pratice that I can distribute this DMZ via EIGRP? Should I just leave it static on the core like this?
DMZ Net = 192.168.150.0/24
Inside Interface = 192.168.200.255
On the core I create a static route "ip route 192.168.150.0 255.255.255.0 192.168.200.255". Or a statement like this would be better for future DMZ additions "ip route 0.0.0.0 0.0.0.0 192.168.200.255"?
