Re: Error: can not add name attribute on PIX 6.01 and 6.11

pmoulay · ‎12-04-2001

After upgrading pix firewall to 6.01 or 6.11, I get the following message: Error: can not add name attribute. I think it is a cosmetic message. Anyone can explain this error?

brford · ‎12-05-2001

Where does this message appear?

I'd advise calling TAC and opening a priority 4 case (informational) when you see something like that.

Liberty for All,

Brian

Brian Ford | brford@cisco.com | brford@yahoo.com | 51 75 61 6c 69 74 79 20 6d 65 61 6e 73 20 64 6f 69 6e 67 20 69 74 20 72 69 67 68 74 20 77 68 65 6e 20 6e 6f 20 6f 6e 65 20 69 73 20 6c 6f 6f 6b 69 6e 67 2e | Email me when you figure this out.

pmoulay · ‎12-05-2001

After some investigation, I found out that only happens on PIX firewall with activation key providing VPN access. I have another firewall with no VPN capabilities and it does not show any error messages. I have tested the firewall with 6.11 and I did not see any issues at all. It is solid. I have a TAC opened with Cisco. I will confirm the results later on.