IGRP does not have a clue about 0.0.0.0 (default route) created by the PIX firewall. The scenario is that my PIX firewall is attached to the internet and is running NAT inside (135.50.0.0). I need to propagate the default route in my IGRP domain. ip ...
I do have a case scenario where the private network is running OSPF and IGRP (135.50.x.y network). The core is running OSPF and we are doing mutual redistribution between the IGRP and OSPF domain. When I redistribute a default route from my OSPF netw...
We have tried unsuccessfully installing PDM 112 (pdm-112.bin) on our pix firewall following cisco doc. We use a TFPT server and we get the message "it is not a PDM file..." Any idea?
After upgrading pix firewall to 6.01 or 6.11, I get the following message: Error: can not add name attribute. I think it is a cosmetic message. Anyone can explain this error?
Yes, it is totally possible. Just done yesterday. Open tcp port 2065 (you might have to open also port 2067 - I did not need to).We have SNA gateway and controllers behind the firewalls that need access to remote site and WAN IBM resources.conduit pe...
In my humble opionion, it become a must when dealing with OSPF and IBGP. With OSPF because the RID use the highest loopback interface. The same goes for BGP. It is easy to find your neighbors. Help troubleshooting. If you have an additional subnet to...
I can confirm that you need to encapsulate IPX traffic with a GRE tunnel. I have set up this solution in a Netware environment from a router to a Catalyst 6000/RSM behind a PIX firewall. int tu0 on router and RSMipx netw xxxxtunnel source ip addtunne...
The pix firewall will work with OSPF as long as your access-list allows it,i.d conduit permit ospf any anyor access-l 101 permit ospf any any + access-group 101 in interface outside. However, we do not recommend running any routing updates through th...