10-08-2013 11:32 PM - edited 03-10-2019 06:04 AM
Hi all,
I have brand new ASA 5525-X firewall and IPS Security Services Processor ( ASA5525-IPS). There is no any configuration in both devices. I try manage the both device using ASDM-IDM. I can able to access the firewall using default management IP address. But while i try to access IPS
"Error connecting to sensor. error loading sesor" massege is coming. I try to ping IPS management ip address from my pc but i unable to ping.
Please any one can help me to resolve this issue.
ciscoasa(config)# sh module
Mod Card Type Model Serial No.
--- -------------------------------------------- ------------------ -----------
0 ASA 5525-X with SW, 8 GE Data, 1 GE Mgmt, AC ASA5525
ips ASA 5525-X IPS Security Services Processor ASA5525-IPS
Mod MAC Address Range Hw Version Fw Version Sw Version
--- --------------------------------- ------------ ------------ ---------------
0 7c69.f68f.b2b3 to 7c69.f68f.b2bc 1.0 2.1(9)8 8.6(1)2
ips 7c69.f68f.b2b1 to 7c69.f68f.b2b1 N/A N/A 7.1(4)E4
Mod SSM Application Name Status SSM Application Version
--- ------------------------------ ---------------- --------------------------
ips IPS Up 7.1(4)E4
Mod Status Data Plane Status Compatibility
--- ------------------ --------------------- -------------
0 Up Sys Not Applicable
ips Up Up
Mod License Name License Status Time Remaining
--- -------------- --------------- ---------------
ips IPS Module Enabled perpetual
ciscoasa(config)# sh module ips details
Getting details from the Service Module, please wait...
Card Type: ASA 5525-X IPS Security Services Processor
Model: ASA5525-IPS
Hardware version: N/A
Serial Number:
Firmware version: N/A
Software version: 7.1(4)E4
MAC Address Range: 7c69.f68f.b2b1 to 7c69.f68f.b2b1
App. name: IPS
App. Status: Up
App. Status Desc: Normal Operation
App. version: 7.1(4)E4
Data Plane Status: Up
Status: Up
License: IPS Module Enabled perpetual
Mgmt IP addr: 192.168.1.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 192.168.1.1
Mgmt web ports: 443
Mgmt TLS enabled: true
Regards,
Manimaran.
10-09-2013 09:35 PM
Hello Mani,
The network setup on this modules is different than previously so my recommendation is follow the next link, determine which will be your network setup and finally configure everything as properly
http://www.cisco.com/en/US/products/sw/secursw/ps2113/products_tech_note09186a0080bd5d03.shtml
Then U should be good,
For more information about Core and Security Networking follow my website at http://laguiadelnetworking.com
Any question contact me at jcarvaja@laguiadelnetworking.com
Cheers,
Julio Carvajal Segura
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide