05-13-2020 07:21 AM
Dear Patrons!
We have installed ASA version 9.13.1(10) on Firepower 1140 but during initial configuration on the FX-OS getting the below error,
Firepower-1140# scope fabric-interconnect a Firepower-1140 /fabric-interconnect # set out-of-band ip x.x.x.x netmask 255.255.255.0 gw x.x.x.x
Firepower-1140 /fabric-interconnect # commit-buffer
Error: commit-buffer disabled while in appliance mode.
Any thoughts on this?
05-14-2020 06:59 AM
The possible cause as follows, the deployment was Appliance mode wherein everything has be configured on the ASA CLI itself.
But the mode can be changed to platform mode by providing the below commands,
"ciscoasa(config)# no fxos mode appliance
Mode set to platform mode
WARNING: This command will take effect after the running-config is saved and the system has been rebooted. Command accepted."
But unfortunately the command itself not available on ASA CLI.
Any thoughts?
05-31-2022 07:29 AM
This is not validate on 9.16.x newest code May 2022:
ciscoasa(config)#
ciscoasa(config)# no fxos mode appliance
^
ERROR: % Invalid input detected at '^' marker.
ciscoasa(config)# sh ver
Cisco Adaptive Security Appliance Software Version 9.16(2)14
SSP Operating System Version 2.10(1.182)
Device Manager Version 7.16(1)
Compiled on Wed 09-Feb-22 01:55 GMT by builders
System image file is "disk0:/installables/switch/fxos-k8-fp1k-lfbff.2.10.1.182.SPA"
Config file at boot was "startup-config"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: