Firepower 1000 Series NTP

[Antony.xavier]

Hi Team,

We are currently planning to replace Cisco ASA 5506-x to Firepower 1000 series FTD device in our network.

In 5506-x we have configuration for NTP servers as below:

NTP authentication-key 1 md5 XXXXXXXX

NTP trusted-key 1

NTP server 10.0.1.61 key 10 source inside

but when I tried to configure the same in FTD 1000 series (Software version 6.4)  through FDM it allows me to configure only server IP address or Name, there is no option for NTP server key authentication, could you please guide me the same in FDM gui and also I am unable to see the option reboot / shutdown option under Device->Settings.

 5506-x we have PPPOE configuration, could you please guide me how to config PPPOE in FTD 1000 series through FDM. 

If you could share me any links where I can get complete information about FTD 1000 series device  

regards,

Antony.

[Rob Ingram · Accepted solution]

@Antony.xavier it is not possible to configure those NTP settings natively in the FDM GUI or using the ASA commands with flexconfig. So it currently is not possible at all.

PPPOE was only introduced on FTD version 6.6, you will have to upgrade.

https://www.cisco.com/c/en/us/td/docs/security/firepower/roadmap/fdm-new-features/firepower-device-manager-new-features-by-release.html