Firepower 3140 - 40G QSFP H40G ACU10M

[AdrianKumar96345]

Hi Everyone

We are installing the Firepower 3140 and need to use the cable 40G QSFP H40G ACU10M on the 40G Slots.

Would anyone know if this will work. I will be most grateful for for your advice as this cable is to be used from another site.

Thanks a lot in advance.

Regards

Ad.

[Marvin Rhoads]

Yes - the hardware installation guide indicates that transceiver type is supported. See Table 7 here:

https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/hardware/3100/fw-3100-install/m-overview.html#concept_fcc_frw_1cb

Normally we refer to the Optics Compatibility Matrix, but it has not been updated with the 40 G transceivers for the 3100 series yet.

https://tmgmatrix.cisco.com/?npf=781&npf=1805&npid=6252

Note this does requires release 7.2 or later according to Table 12 here:

https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/roadmap/management-center-new-features-by-release.html