Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello EveryoneWe are facing issues on registering 1832 Access Points and 1815 Access Points on the Network.We keep on getting the following error and APs keep on rebooting.1832 Access Point[*07/06/2024 05:43:32.0000][*07/06/2024 05:43:32.0000] CAPWAP...
Hi EveryoneWe are running into continuous issues where the Switch Management at remote sites pretty slow over SSH, the Access Points lose association with the Controller at the Hub.Currently, we are operating a 140Mbps link at the Spoke Site. The QoS...
Hi Guys.We are running Firepower 3140 Appliances. There are 2 * 40Gbps connection. The Physical (ETH2/1) 40Gbps interface has the MTU set as 9000 whilst the Sub Interface (ETH2/1.10) and (ETH2/1.20) has the MTU still at 1500In this scenario,1. Is the...
Hi EveryoneWe are installing the Firepower 3140 and need to use the cable 40G QSFP H40G ACU10M on the 40G Slots.Would anyone know if this will work. I will be most grateful for for your advice as this cable is to be used from another site.Thanks a lo...
Hello EveryoneWe are currently having 1 * Carrier in the VPN 0 (G0/0/0) whilst the Clients are in VPN 20. We want to connect Private SIP Trunks to the network and requesting for your advise if the approach below is fine.1. Connect the Private SIP Tru...
Thanks a lot KananBasically, we are trying to achieve the following:1. The site uses Hard Phones and Soft Phones on PCs and Mobiles. This is already working.2. The PCs and Smart Phones for all the internet traffic will be routed off the G0/0/0 - ISP ...
Thanks KananThe following was used to verify the WAN.1. The ping tests to the edge was fine without any packet drops. Ping from WAN to WAN was fine without any drops. Ping from LAN to Remote LAN had a lot of packet drops to even losing the remote lan...
Thanks a lot RogerHave modified as and the alias got accepted. Thanks a lot for it. But when i tested by breaking the link between the CUCM and the Local Site, noticed the following problems. 1. The Cisco 7811 and 3905 Phones displayed the " Limited ...
Thanks a lot Roger I tried to configure but ended with this error. Remote1(config-register-pool)#alias 1 7775551200 to 75000Failed: CME mode!Have also tried to change the Voice Register Global to CME Mode and still ended with the same error. We will ...
