Firepower 4110 FTD Hardware Bypass

[houren]

Hi Community,

“Hardware Bypass is not supported in high availability mode.”

https://www.cisco.com/c/en/us/td/docs/security/firepower/660/configuration/guide/fpmc-config-guide-v66/inline_sets_and_passive_interfaces_for_firepower_threat_defense.html

Does it mean that if we have 2 units for Firepower 4110 configured as Active-Standby, both with Fail-to-wire Network Module, the Hardware Bypass (Fail-to-wire) function will not work ?

Thank you

[Marvin Rhoads · Accepted solution]

Correct. It will not work.

[houren]

Thanks for your confirmation Sir, i have the same confirmation from Cisco GVE too.