Firepower 4110 LED Failover-pair

[patoberli]

Hello all

I've got a fairly new Firepower 4110 pair, running ASA 9.12.x software. I noticed that the new chassis doesn't have an LED for Active/Standby. All LEDs on both chassis are always green.

Is this correct or might this be added in a future software release? I found that quite a useful information while troubleshooting on-site.

[Marvin Rhoads · Accepted solution]

Correct - the Active (ACT) LED is not currently supported but it will be in a future release.

https://www.cisco.com/c/en/us/td/docs/security/firepower/4100/hw/guide/b_install_guide_4100/overview.html#concept_4386239138B84D40979C3AFA97BA852D

[patoberli]

Thanks for the confirmation.