Firepower 7010.EXPERT menu after restore.

[n.avramenko87]

Good morning!!! I need you help again!
So what i have:
FMC 6.1.0.2 (build 57)
And I resrored OS from Resore image to my 7010 (Cisco Fire Linux OS v6.1.0 (build 37))
But I have problem. I do not have EXPERT mode on my 7010, so i can not connect it to my FMC.
In manual I saw that wnen I first login to device after restoring - i must see EULA. But I do not see it.
May be my 7010 does not support this versions? But I see in manual that it must work.

May be only 5.4 version I can use for restore?

I need your advices.

Thank you!

[n.avramenko87]

As I understand it, I am using no image for recovery. I have a Firepower Management Center. And I need to restore the operating system on the 7010 physical hardware. Which recovery image should I use? Sourcefire_3D_Device_S3-6.2.0-362-Restore.iso .

Sourcefire_3D_Device iso - Is it iso for resoringn oh physical device? Thank you!