04-25-2016 12:53 PM - edited 03-12-2019 05:59 AM
Hi everyone,
I recently re-imaged FirePOWER module (6.0.0) on a Cisco ASA 5512-x and I'm having this error on the access control policy section:
Where does that reference for the policy come from? I haven't deleted anything, it's a fresh install.
Any ideas?
Thanks
Solved! Go to Solution.
04-26-2016 11:25 PM
Hi,
The error indicates that it might be a bad install where is some issue occurred during reboot,
you can try importing the access control policy from any other ASDM and see if it works.
If still the issue occurs, you will have to follow the below steps :
1) uninstall the SFR sw-module module sfr uninstall 2) wr mem 3) Reload ASA ( in Maintenance window) 4) load the boot image (6.0.0.1055) 5) Load the package file
Check the ASDM again and see if the policy apply works.
Rate if it helps.
Thanks,
Ankita
04-26-2016 11:25 PM
Hi,
The error indicates that it might be a bad install where is some issue occurred during reboot,
you can try importing the access control policy from any other ASDM and see if it works.
If still the issue occurs, you will have to follow the below steps :
1) uninstall the SFR sw-module module sfr uninstall 2) wr mem 3) Reload ASA ( in Maintenance window) 4) load the boot image (6.0.0.1055) 5) Load the package file
Check the ASDM again and see if the policy apply works.
Rate if it helps.
Thanks,
Ankita
04-27-2016 01:06 AM
Thank you for answering.
I was in a hurry so I did the steps that you suggested (uninstall) before reading your answer and it worked!
I have an explanation on why it was a bad install:
I had an issue with the EULA step while using PuTTY (incoming packet was garbled on decryption) and it kept logging me out so I did the rest of the configuration with the ASDM wizard (huge mistake) and the access policies were not created.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide