firepower module recover

[welmjendel]

hello guys,

i would reimage my module firepower 5.4.1.1 and install 6.1.0, if this action was done the license (malware & url filtring) still available on my asa ?

regards,

wajih

[syeda3]

Updating the Firepower Management Center to Version 6.1 may delete or disable Classic licenses for managed NGIPSv, ASA FirePOWER, 7000 Series, and 8000 Series devices. Before you begin the update, contact Support for a script you can run to prevent this issue.
If you do not run the script, after the update, use the Classic licenses page (System > Licenses > Classic Licenses) to check and reinstall any deleted licenses. Use the Device Management page (Devices > Device Management) to edit Classic managed devices and reenable the appropriate licenses.

http://www.cisco.com/c/en/us/td/docs/security/firepower/610/relnotes/Firepower_System_Release_Notes_Version_610.html

[Marvin Rhoads · Accepted solution]

The licenses is applied from and resides on the management system - FirePOWER Management Center (or ASDM if you are using that).

If you re-image, you should remove the current device from the manager and then you will have available licenses. When you re-add it, you re-apply those same licenses back on the device.

[welmjendel]

thank you for your response.

[Marvin Rhoads]

You're welcome.

Please rate it if the answer helped.