01-23-2019 08:31 AM - edited 02-21-2020 08:41 AM
My company purchased some Cisco 2110 runing firepower threat defence v6.2.3 OS.
As I work remotely got someone to patch the new Cisco 2110 to Lab PC console port as well as 2110 ethernet 1/2 (inside interface) to a lab switch port that I can route to. The idea was simple one, we use inside data interface as management interface so all I had to do is to set eth1/2 interface on the lab IP subnet and change the default gateway so I can route out of the lab then I can get to the 2110 from anywhere via IP and then I can configure the box via web based Firepower Device Manager.
Read the config PDF and half the command refs can not work out how to configure
1) configure ethernet1/2 inside int as management/data interface and change IP
2) set/change default gateway
3) disable dhcp on 2110 so it doesnt interfere with the lab DHCP
4) disable management interface "interface Management1/1"
What used to be simple like "interface ethernet1/2" then configure int IP or a single command to set default gateway is now mission imposible. "no" infront of the command or anything else I can think of no longer works. How do we now go into interface configuration via CLI. I am sure there is a simple logical solution to this, any ideas/suggestions are much appreciated? Tx
Solved! Go to Solution.
01-23-2019 07:37 PM
01-23-2019 09:06 AM
Hope this guide help you :
01-23-2019 07:37 PM
01-24-2019 02:58 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide