10-18-2016 04:34 PM - edited 03-10-2019 06:41 AM
Can I do Firesight Active Discovery when Firepower is configured in monitor-only mode.
10-18-2016 05:37 PM
Yes, you can integrate FireSIGHT/FMC with AD even if the sensors are running in monitor-only mode.
I hope this helps!
Thank you for rating helpful posts!
10-18-2016 11:37 PM
Hello Team,
Refer the following link if that link helps you.
http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118738-configure-firesight-00.html
Rate helpful posts.
Regards
Jetsy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide