730
Views
0
Helpful
1
Replies
firesight simulation mode
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2016 09:50 AM - edited 03-10-2019 06:37 AM
is it possible to run a firesight sensor in "simulation" mode ? i.e can it show if a particular access control policy was enforced what would be allowed and what would be blocked ?
Labels:
- Labels:
-
IPS and IDS
1 Reply 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2016 11:21 AM
Hello Tejas,
Did you mean the monitor only mode ?
Monitor only mode just sends a copy of the traffic and no actions will be taken on that traffic.
Rate if this answer helps you.
Regards
Jetsy
