when i deploy my FTD appliance inline (running on a 4120 chassis) my backups (from a windows server to EMC data domain appliance) slow down dramatically the source and destination are in different subnet and traffic passes thru the firepower. when i...
i recently purchased additional licenses for my 4100 firepower appliances
i have an edelivery email from cisco, but dont see them in my smart account
what is the process of associating the new licenses with my smart account
i have a few Cisco 7937G conference phones that i want to authenticate against ISE. the only option they support is EAP MD5 and i have configured the secret on the phone.
my question is where do i configure the secret for comparison ? do i configur...
are there any best practices for using the intrusion policy on the firepower appliance ?
you have the "intrusion policy used before access control rule is determined" as well as intrusion policy that can be applied to a specific access control rule...
i want to setup 802.1x authentication with EAP-MD5 on certain cisco phones. the EAP-MD5 password is configured on the phones.
where do i enter the EAP-MD5 password in ISE so the values can be compared ?
or is my understanding of EAP-MD5 incorrect...
it does not.
i know how the pairings work. my question was i just see 1 pair enabled and the other 2 disabled. where can i find the option to enable the other 2 pairs
the problem is the rule being referenced is actually disabled in the intrusion policy.
it is not set to drop.
thats why is surprising that i am seeing an intrusion block
