- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2016 03:52 AM - edited 03-12-2019 06:00 AM
Hi,
What is the maximum response time permissable between a firepower device and the FSM? We'd like to have firepower devices managed in other contries from the same FSM.
Thanks in advance
Solved! Go to Solution.
- Labels:
-
NGIPS
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2016 04:10 AM
Hi
If there is minimum of 256 KBps of bandwidth between FMC and sensor , that should be enough for normal policy push. Upgrades might take longer if the bandwidth is not enough.
Hope that helps.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2016 04:10 AM
Hi
If there is minimum of 256 KBps of bandwidth between FMC and sensor , that should be enough for normal policy push. Upgrades might take longer if the bandwidth is not enough.
Hope that helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2016 04:15 AM
Thanks for the prompt response however I'm specifically looking for the round trip delay in terms of 30ms for example.
If the device is roughly 70ms rount trip does this have any adverse effect on anything?
Thanks

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-03-2016 07:01 AM
Were you able to get an answer to this? I have the same design
Also, are there concerns with the FMC being accessed over a VPN tunnel (tunnel terminated on ASA running FP) ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-18-2017 02:17 PM
Good day,
Does anyone have an answer for this?
