First time VPN setup

[wperez001]

Here goes:

I have VPN Licenses and would like to start using them, unfortunately ASA is not as straight forward to set up I tried the wizard with no success. an guide on how I can setup remote access so the users can jump on RDP sessions? attached is my license count.

[JohnTylerPearce]

Looks like you will be installed th Cisco IPSec IKEv1 VPN then.

What version of code is the ASA running?

[wperez001]

ASA Version 8.2(3)

ASDM 6.3(5)

When I go to the Wizard I select:

* IPSEC VPN >

* Remote Acesss > VPN Tunnel Interface (Outside) + Enable Inbounf IPsec session to bypass interace access list

* Cisco VPN Client, Release 3.x or Higher

* Pre-shared Key (Typed in a random password) + Tunnel Group Name = VPNNAME

* Authenticate using local user database

* Created users

* Enter a pool  (this where it gets trickey, do i just create a range withing my local lan ip block?)

* Attributes Pushed to clients(Do I need to fill this out? it said optional)

* IKE Policy (does it matter what i put) I have Encyption DES, 3DES, AES- 128/192/256||Authentication MD5 or SHA and Diffie-Hellman group 1,2 or 5

* IPsec Setting (optinal) Do I nee to fill this out? it has Enable Perfect Forwarding Secrecy enabled

[Julio Carvajal]

Hello Wil,

Perfect Forward Secrecy  is optional( used to make sure the same key is never used again) , so you can decide whether to use it or not.

Are u able to connect?

Rate all of the helpful posts!!!

Regards,

Jcarvaja

Follow me on http://laguiadelnetworking.com

[wperez001]

No connection yet, I have the Anyconnect client and the VPN Client, Ive attched 2 screenshots. Not sure which one both do not get me connected Thanks guys for yout time