cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
802
Views
0
Helpful
2
Replies

floodguard on pix 525 ver.7.1(2)

sercopi
Level 1
Level 1

Good morning I have upgrade the relase of my Pix Firewall, from 6.3 to 7.1(2)

Now I need the feature floodguard, (which I had enable on 6.3) but I don't find the CLI to enable floodguard, anyone know the right command line to active it?

I've read the link:

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fba01.html

but i don't find the command about floodguard.

Any information that you can send me are welcomed.

Best Regards

Davide

2 Replies 2

hemendoz
Cisco Employee
Cisco Employee

Hello Davide,

The floodguard command is now a deprecated command and is no longer needed. The floodguard feature is always enabled.

Please review

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_upgrade_guides09186a0080369ee2.html#wp1462575

for more info.

Hope that helps! Please rate if it does.

Thanks,

hemendoz

Hi hemendoz thanks very much for your answer, now I'm reading the link that you suggested me.

Best Regards

Davide

Review Cisco Networking for a $25 gift card