Hi,I configured CSR1000v inside the SandBox, and now I would like to route streaming telemetry into the VPN to my PC is possible? Best Regards--Giovanni Davide Saccà
Hi all, I need to monitoring IP SLA on board of a Cisco Device. I have a question: Cisco device support only snmp trap?For example as I saw:snmp-server enable traps ipslasnmp-server host x.x.x.x version 2c community xxxx or I can use also snmp call f...
Hi all, I'm finding if is possible to configure a WLC to send syslog lines to a syslog server port different to 514/UDP. I'm checking here:https://www.cisco.com/c/en/us/support/docs/wireless/4100-series-wireless-lan-controllers/107252-WLC-Syslog-Serv...
Hi all, I'm using NWC hardware health script (check_nwc_health) but it's not able to have information about FAN status for a c7200 router; the output of the script for the FAN is: SNMP error the requested table is empty or does not exist. Seems like ...
Good eveningI have in produciton 2 Cisco IPS Device Type: ASA5585-SSP-IPS10 IPS Version 7.1.4(E4) with signature version 664.0 I have enabled on Sensor1 a few signatures and after I had to enable the same signatures on Sensor2, by flag individual che...
Hi thank you for your reply, should you send me the ports may be blocked over the VPN? And in details at which side of the VPN may be blocked? At Cisco side, or at my PC side? What I know is that necessary at least port 57000 from the device to the ...
Thank for your help marce1000. I browse the suggested MIB as indicate in the guide, in details look the .png file in attach. The output of snmpwalk is in the file.txt in attach. Checking seems like the FAN module is not listed. Where I can find (exce...
Hi marce1000,thank you for your reply, I read the user guide use suggest me, where I already find that the FAN may be contain into CISCO-ENTITY-SENSOR-MIB and/or the CISCO-ENTITY-FRU-CONTROL-MIB . I'm already download each MIB you suggest me. Now my...
Good evening Ivan,thanks very much for your reply, if I could have another doubt. Should I apply a new crypto map to a "virtual" interface which I will create under the outside interface?For example under the interface GigabitEthernet0/0.1Best Regard...