FMC and FTD 802.1 Q Trunk with Multiple VLAN

[unifilNCC]

HI ALL,

I have recently setting up Cisco FTD and FMC , i am trying to create a two port channel one will be INSIDE and Another will be OUTSIDE, these port channel i added two interface each for inside and Outside. 

what i am trying to do to allow 8 vlans (Inside) through Port Channel and Outside Port Channel i want the same vlan to be in and out Is it possible i need some urgent advise on this.. 

also i dont see anywhere trunk configuration option inside the FMC version 7.2

Lav Kumar

[Marvin Rhoads]

VLAN IDs must be unique across different subinterfaces.

[unifilNCC]

Hi marvin,

Unique Vlan ID meaning, you mean to create same Vlan ID in Diferent subinterfaces.. which is not allowed in the FMC.

let me make it more clear about my challenge: i am trying to configure with inside interface as trunk allowing Vlan 3,4 ,5   than pass the same to outside interface with the same Vlan 3,4,5  this senario i am trying to put the FTD create between the servers communication within the same vlan 3,4,5. i hope it is clear.

[Marvin Rhoads]

Passing the same VLAN from inside to outside implies you are using transparent mode vs. the much more common routed mode. Is that what you are trying to do?

[unifilNCC]

Yes i have configured the FTD in Transparent Mode, but i am not getting any luck it is not working i need some advise.. whether it will work or not..?/

[unifilNCC]

Any Advise how to do it , that will be appreciated. 

[Marvin Rhoads]

If you search google for Cisco Live presentation BRKSEC-2020, you will see a simple explanation on slides 169-172.