cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
340
Views
0
Helpful
1
Replies

FMC not showing Ethernet port on FPR2100

mark.stewart1
Beginner
Beginner

HI,

We are having an issue where the FMC no longer shows the Ethernet port form the FPR2100.

on the FXOS interface i can see this:-

FW /eth-uplink/fabric/interface* # show

Interface:
Port Name Port Type Admin State Oper State State Reason
-------------- ------------------ ----------- ---------------- ------------
Ethernet1/2 Data Enabled Up Up

but under FMC it just goes from Ethernet 1 to 3, 2 is missing.

tried a resync from FMC interfaces but no luck.

 

1 Reply 1

Marvin Rhoads
Hall of Fame
Hall of Fame

@mark.stewart1 what does "show interface Ethernet 1/2 " report from the FTD cli (clish)?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: