Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,We are having an issue where the FMC no longer shows the Ethernet port form the FPR2100.on the FXOS interface i can see this:-FW /eth-uplink/fabric/interface* # showInterface:Port Name Port Type Admin State Oper State State Reason-------------- --...
Hi,We have an issue where we have two fpr2100's in HA mode connected to a stack of switches which are then on a fibre ring.Currently the HA cables are connected to the primary switch in each of the stacks, which work until one of the primary switches...
Hi, a colleague was upgrading some ISA-3000 devices to the ftd firmware, but has some how come unstuck with this one and now it has come to me to look at, below is what i get when trying to tftp the ftd-boot file. ADDRESS: 192.168.100.131NETMASK: 255...
HI,I have 2 IE2000-8TC-G-E devices that I wish to HSRP between, issue being i dont seem to have available all the subset of the standby command.They are both lanbase, if i set the below on a port, i get the standby command available:-interface fFastE...
Hi, I have this current setup, two sg550 switches connected to a 3750 which is in turn has an external connection to the internet.from the 3750, i can ping both sg550 and also 8.8.8.8 over the internet.what i want to be able to do is ping 8.8.8.8 fro...
Thankyou for your reply, but we are having to look at all failure modes, and if that fibre failed between the firewalls for the HA, we would be in the same situation so we are trying to work something out 'outside of the box' as they say.As when the...
here layout of network.my other options are create a dedicated link between the firewalls, but they are not local to each other.or remove second trunk link to secondary switch, so firewall can still go master master, but no comms to network.
Sorry original filename in attempt below, that was purely and simply to try a very simple filename just in case.rommon 13 > tftpdnldADDRESS: 192.168.100.131NETMASK: 255.255.255.0GATEWAY: 192.168.100.1SERVER: 192.168.100.130IMAGE: ftd-boot-9.15.1.0.lf...
ok, interestingly, the MD5, on my pc matches the one from the cisco website.but the md5 shown on the device after it has downloaded is totally different???tried two different tftp servers now also.tried solarwinds and tftpf64 any ideas? thanks, mark
