FMC Object Management - added network objects not seen

[tmoore]

Running FMC 6.2.3.3 with multiple domains with FTD 2100.  Added network objects which are visible when scrolling through the object pages.  But are not seen when using the search filter and entering the ip address or name.  Nor are the new objects showing up when trying to add a Static Route. At the "Add Static Route Configuration" page the "Available Networks" does not show all the added Network Objects.  I clicked the reload icon the amount doesn't change.  How to I get these objects seen?   

[jesusko]

Did you find any solution for this problem? I have the same issue and so far no luck.
Thank you

[kvandegrift]

We are seeing the same issue on FMC 6.2.3 but have not found a cause or solution.  This problem has just appeared in the last week for us.  Anyone have a possible explanation?

[jesusko]

Hi,

Eventually I raised a TAC case and this was the solution from them:

Login to FMC through SSH and run this commands under root user:

# rm -r /var/opt/CSCOpx/MDC/search/
# pmtool restartbyid DCCSM

After this a web interface was showing ”System processes are starting, please wait” about 10 minutes and afterwards everything was working again and problem solved. I guess this is the bug CSCvp11760.

[Peter Beshay]

these 2 commands work for 7.4.0.118 but the problem i have to do that every time i add object
is there a permanent fix or just this work around

[Peter Beshay]

I upgraded the FMC2700 to version 7.4.2.1-30 and the issue still exist , do any one have this issue and resolve it some how?

[aallahbahsh]

I have FMC Version 7.4.2 (build 172) virtual, cannot find the objects when I search them. Any solution?

[Thiruchelvam Thurairaj]

After updating the Firewall Management Center to 7.4.2.1 (objects were stiil not visible) and did the same as Jesuso proposed (CLI commandos), now I see the network objects under Object Management. And also if I create new objects they are visible under the object management.

If it will stay like this I don't have a clue!

Time will tell.

[Peter Beshay]

For me, any new objects I create, I must execute the CLI commands, or they will not show up or be usable in firewall access rules.

The TAC support has not been able to fix it till now.

[Thiruchelvam Thurairaj]

Hi,

I have tested it just now.

When I have creatd an object directly under a access-control rule or via Object Management, object is still visible for me. 7.4.2.1 is the version I am using for the FMC and CSFW's.

[Peter Beshay]

both, for me, are not working, I did full reboot as well with the same result