FMC showing wrong model

[muath1987]

Hello

I finsised a mogartion of FMC appliance (4000 to 4600), the primary appliance is up and everything looks good on it but the secondary FMC showing model 4000 while it should be 4600, there is a command can be run from shell which can modify the model, please if anyone knows this command post it here.

BR

[UdupiKrishna]

The CLI procedure is/was meant for legacy Sourcefire hardware. Can you run "show model" from the cli of both FMC(s) and verify the output returned?

[Marvin Rhoads · Accepted solution]

You can use this script as root from the FMC expert cli:

/var/sf/etc/model-info/configure-model.sh 

[muath1987]

thank you very much

[Jitendra Kumar]

Yes @Marvin Rhoads ,

I can see your old comments that resolved the issue.

@muath1987  you can check below use case if its help you

https://community.cisco.com/t5/network-security/can-fmc-running-in-vsphere-be-migrated-to-aws/td-p/4569305

Thanks,

Jitendra