FMCv & FTDv

[jaketheape]

Hi, I'm using GNS3 for a test lab. I'm trying to bring up 2x interfaces on the FTDv from FMC Gi0/0 and Gi0/1 - Gi0/0 is my inside interface, Gi0/1 my outside. I'm running the FMC in Evaluation mode and have 90 days of functiionality for testing.

When I deploy I keep getting a failure 'inline link mismatch alarms (test failed as shown in the image.

Anyone encountered this issue - I'm struggling to bring the 2x interfaces from admin down to up.

I am running the firewall in transparent mode, not routed.

Any help greatly appreciated

[Chakshu Piplani]

Inline Link Mismatch Alarms - This module monitors the ports associated with inline sets and alerts if the two interfaces of an inline pair negotiate different speeds. 

Source: https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/health_monitoring.html

Regards,

Chakshu

Do rate helpful posts!