Is there a trick to getting one of the SFP+ interfaces to come up? I have an FPR2130 in platform mode with a 10Gb SR module plugged into the 1st SFP+ interface.
from FXOS I can see the interface is an enabled admin state, but the operational state is down. This appliance is running the ASA code, within that the interface is showing down and the BW 1000Mbps?!?
I've manually configured the link speed to 10Gbps and full Duplex in FXOS, no change.
If I stick the same link into our core switch the link comes up, so it's not an issue with flipped fibres etc.
Any tips or tricks?
Cheers