09-23-2016 02:42 AM - edited 03-12-2019 01:18 AM
I am trying to run TFD 6.1 in our lab enviroment to test it - I installed Firepower NGFW Virtual v6.1.0 on ESXi 5.1 or 5.5
image to our ESXi 5.5 - I tryed to deploy both versions either VI or ESXi - but I am not able to setup management IP address. In case of ESXi I setup it in initial setup, then I tried it trough command in CLI (Console) but even it responeded the change was made I can still see the IP is not setup
there is "no ip address" under interface Management 0/0.
The same with VI deploy where the IP is setup during deployment.
Does anybody met the same behaviour? It seems the IP configuration is ignored by some unknown reason.
Note: Another thing which is very frustrating for me - I cannot find any way how to setup pageing in vmware console - output like show running is rolled out and I cannot find any way, how to scroll it back to see the beginning.
11-28-2016 07:21 AM
11-28-2016 11:41 PM
Hi, pnavratil
Thank you for your reply, I just figure it out, like 5 minutes ago, the same thing. :)
BR,
Corvinux
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide