Solved: FTD cli for unassigning IP from interface

AmmarHermiz14196 · ‎06-08-2023

Hi all,

Can someone please tell me how to unassign IP from interface using FTD cli. I made a mistake and I assigned an IP to the Management interface and now I can get to the gui for my FRP1010.

I need please the cli to take off the IP and put back to UNASSIGNED.

Thank you,

Ammar

Rob Ingram · ‎06-08-2023

@AmmarHermiz14196 To reconfigure the mgmt interface use the configure network command, e.g. - configure network ipv4 manual 192.168.45.45 255.255.255.0 192.168.45.1. Just change the IP address back to the default IP address.

You configure the data interfaces you must to do this from the GUI.

View solution in original post

Rob Ingram · ‎06-08-2023

@AmmarHermiz14196 To reconfigure the mgmt interface use the configure network command, e.g. - configure network ipv4 manual 192.168.45.45 255.255.255.0 192.168.45.1. Just change the IP address back to the default IP address.

You configure the data interfaces you must to do this from the GUI.

AmmarHermiz14196 · ‎06-08-2023

Rob. again you are the Man!!!

Thank you VERY much.

I am learning a lot from you! I wish Cisco had some service contract for personal not only for business . Maybe one day!

Thank you,

Ammar