FTD integration with Cdo

[Vishal6]

Hi all, I'm following below link to sync FTD model 1140 to cloud manage FTD (CDO). As per document we only wants to power on device and add serial number and syncing will be complete. Is it only that much enough to register the device on CDO or any other configuration is required like interface, route towards outside to make communication with cdo

[ccieexpert]

https://docs.defenseorchestrator.com/c_procedure-for-onboarding-an-ftd-using-the-devices-serial-number.html

the outside or the management interface should be connected and be able to get DHCP ip so it can seamlessly connect to CDO provide no other firewall is blocking access etc..

the link above explains the sites it goes it..

• The outside or management interface of the device must be connected to a network providing DHCP addressing. Typically, the device has a default DHCP client on the outside or management interface.

  Note	If the management interface is connected to a network having a DHCP server, it takes precedence over the outside interface for Linux stack initiated traffic.

• Your outside or management interface needs to access to be able to access the following Security Services Exchange domains for the serial onboarding method.

[AHack210 · Accepted solution]

Hi, here is a video demonstrating low touch provisioning with FTD and cdFMC via CDO.

Requirements: internet access via management or data-plane interfaces and minimum FTD version 7.2.

Hope that helps!

-A