06-11-2017 07:45 PM - edited 03-12-2019 02:29 AM
Hello!
I have a question about FTDv and its management interface.
During cli installation wizard I assigned static ip address to the management interface. What interface it should belongs to?
In show interface ip brief Management interface has no assigned ip addresses, but in show network I can see br1 interface with assigned address.
But, I can't ping this ip address, even it's own address. Also, I can't see this interface in show interfaces ip brief command.
What is the problem?
06-11-2017 08:28 PM
Also, gigabit interfaces are in administratively down state. And I didn't found any command in CLI to enable it.
And, it is really strange thing, but I am able to ping management ip address from network, and I am not able to do it using CLI directly on device.
06-05-2018 12:09 AM
09-26-2018 07:15 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: