Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about host mobility in SD-ACCESS. I understand that all switches in Campus have same SVIs so i don't need to change ip when i move from one switch or AP to another.But my question is what is the practical using of IP Mobility? I mea...
Hi, folks!I am trying to make following setup:- There is a WAN router , connected to C2960S switch port gig 1/0/23, This port is in trunk mode, but WAN connection is in Vlan 1- There is a ESXI host behind port 1/0/13 on same switch. There are some VM...
Hello!
I have a question about FTDv and its management interface.
During cli installation wizard I assigned static ip address to the management interface. What interface it should belongs to?
In show interface ip brief Management interface has n...
Hello!
I have a questions about how does IP phone can be authenticated using certificates in 802.1X.
1) As i understand, IP phone can contain two types of certificates - LSC and MIC. Which one can be used during 802.1X authentication?
2) What comp...
Hi, folks!I have the questions about IOC scan in AMP.1) What is the purpose of this feature? Is it like a full system scan in any other antivirus/antimalware software like McAfee?2) Does every malware has it's own IOC? Or there is a one big cisco IO...
Hi, ScottThank you for reply.It is probably a very stupid questions, but i can't not to ask.- imaging cart in a hospital. You mean terminal used by staff, like this one:https://imagetechnologygroup.com.au/products/medical-cart- What is the reason to ...
Hi, all!
Thanks for your replies, i will check it and inform you about results.
You wrote
Once you configure the above commands, the port can be used as a normal access port (while it still works as destination port).
But even with this command,...
Also, gigabit interfaces are in administratively down state. And I didn't found any command in CLI to enable it.
And, it is really strange thing, but I am able to ping management ip address from network, and I am not able to do it using CLI directly...
