cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1165
Views
0
Helpful
3
Replies

FTDv Management interface

Evgeniy Ivanov
Level 1
Level 1

Hello!

I have a question about FTDv and its management interface. 

During cli installation wizard I assigned static ip address to the management interface. What interface it should belongs to? 

In show interface ip brief Management interface has no assigned ip addresses, but in show network I can see br1 interface with assigned address. 

But, I can't ping this ip address, even it's own address. Also, I can't see this interface in show interfaces ip brief command.

What is the problem?

3 Replies 3

Evgeniy Ivanov
Level 1
Level 1

Also, gigabit interfaces are in administratively down state. And I didn't found any command in CLI to enable it. 

And, it is really strange thing, but I am able to ping management ip address from network, and I am not able to do it using CLI directly on device.

Prabakar jaya
Level 1
Level 1
Was this fixed.. I am facing the same issue

me to, have you figured it out?
Review Cisco Networking for a $25 gift card